Error Code: FC - Compressor Drive Fault

This error is signifying a fault between the compressor and external PCB. 

To fix the error code you need to do the following: 

  • Check the connections between the compressor & PCB and clean and tight 
  • Check for any damage to the PCB, burn marks will show a faulty PCB. Replace the PCB if faulty
  • An engineer will be required to check the refrigerant in the system is at the correct level, this error code normally appears when the system has no gas and the compressor has burnt out. A new compressor/outdoor unit is required. 

note: the compressor is connected to the IPM module on the 18K and 24K units. It's connected to the main PCB on the 9K and 12K units. 

To purchase any new parts, contact us via email at info@airconditioningcentre.com or call us at 0370 3344 556.

 

  • 123 Users Found This Useful
Was this answer helpful?

Related Articles

Error Code: F1 - Communication Fault

The error code ' F1' means the indoor unit PCB and outdoor unit PCB cannot communicate with each...

Error Code: F2/F3 - Internal Temperature Sensor Fault

Both error codes signify that there's a problem with the internal sensor. The difference between...

Error Code: F4 - Internal Fan Fault

The error code 'F4' is indicating either a fault with the indoor fan motor or indoor PCB. To...

Error Code: F6/F7/F9 - External Temperature Sensor Fault

All 3 error codes means there is something wrong with the sensors - the difference between the...

Error Code: F5 - IPM Module Fault ( Intelligent Power Module )

The IPM module is the inverter module which controls the speed of the compressor and the outdoor...