Error Code: E4 - Units Abnormality Protection

When this error code appears, it means there is a problem with the hose pipe - the heat is being kept in the hose pipe and not being transferred properly. 

To fix the problem you have to do the following: 

  • Check the heat is going through the hose pipe and being let out properly to an open space. Make sure the air is not being let out into a small space. This can be the course of the problem as the hot air is not being expelled properly, so it is being kept in the hose pipe - therefore making it overheat.  
  • If you're venting this out through a wall with a vent on the other side, make sure there is no downsizing of the pipe as this will restrict air flow therefore causing the unit to overheat. This can also be caused if the vents on the other side are not opening or letting out enough air.

If the problem is still occurring, you'll need to send the unit back to us - as the problem will need to be fixed by our in house professionals.  

You can contact us via email at info@airconditioningcentre.com or call us at 0370 3344 556. 

 

  • 3 Korisnici koji smatraju članak korisnim
Je li Vam ovaj odgovor pomogao?

Vezani članci

Error Code: E1 - Outdoor Pipe Temperature Sensor Fault

When this error code appears it means there is a problem with the outdoor pipe temperature...

Error Code: E2 - Room Temperature Sensor Failure

When this error code appears it means there is a problem with the room temperature sensor....

Error Code: E3 - Coils Sensor Failure

When this error code appears it means there is a problem with the coil sensor.  You'll need to...

Error Code: E5 - Water Level Over the Limits

When this error code appears it means there is a problem with the water level.  You'll need to...

Error Code: E7 - The Ambient Temperature Is Too Low

When this error code appears it means there is a problem with the ambient temperature.  You'll...